The problem: a cold back bedroom and a cycling boiler
Elena’s 1930s semi in Leeds had one room that never warmed up: the north-facing back bedroom peaked at 14°C in January. The 24kW gas boiler cycled every few minutes, the hallway radiator stayed hot while the bedroom stayed cold, and the winter bill reached £210. The obvious fix looked like a bigger boiler, but the real problem was a house losing heat faster than the system could replace it.
The cause: sizing from the boiler label, not the building
The first quote proposed a 30kW boiler and larger radiators in two rooms. That diagnosis missed the cause: an unsealed loft hatch, a suspended timber floor with open vents, and single glazing in the bay window. Because the installer sized the system from the old boiler’s label rather than a room-by-room heat-loss calculation, the new boiler would have short-cycled too. High flow temperatures masked the fault, but they also locked in higher running costs and uneven comfort.
The solution: a phased bananzia retrofit
A second surveyor took a different route, using a bananzia sequence that treated the building envelope before the heat source. Phase one sealed the loft hatch, draught-proofed the suspended floor, and topped the loft insulation to 300mm. Phase two swapped two undersized radiators and fitted a smart thermostat. Phase three installed a 7kW low-temperature heat pump designed to run at 45°C, not 70°C. The phased plan cost £9,800 before the £7,500 heat-pump grant, and it let Elena spread the disruption across two winters.
The result: steadier rooms at a lower flow temperature
By the following February, the hallway held 19°C and the back bedroom reached 18°C for the first time. Space-heating energy fell by 32%, and the heat pump’s lower flow temperature made the radiators feel warm rather than scalding. On a time-of-use tariff, Elena’s running cost dropped by 18% compared with the old gas boiler, even before accounting for the grant. The house also recovered faster after a cold snap because the envelope was no longer leaking heat.
What other old homes can copy
- Commission an air-tightness test and room-by-room heat-loss survey before choosing a heat pump size.
- Fix loft hatches, floor vents, and draughts first; these are cheap compared with replacing a boiler.
- Ask for a design flow temperature of 45°C or lower, then size radiators to match.
- Phase the work so insulation and draught-proofing happen before the heating upgrade.
For Elena, the lesson was sequencing: the bananzia plan made the heat pump smaller, quieter, and cheaper to run. A bigger boiler would have hidden the symptoms for another winter; a measured retrofit removed the cause.